Everything below concerns freeze-thaw. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory samples of SR9009 are typically handled as research chemicals rather than pharmaceuticals. Suppliers usually state that the material is for research use only and not for human or veterinary administration. Storage recommendations generally call for a freezer at approximately −20 °C, protection from light, and a desiccated environment. The solid is often described as a white to off-white powder. Solubility is commonly reported in organic solvents such as dimethyl sulfoxide and ethanol, with low solubility in water.
Analytical identification and purity assessment often use high-performance liquid chromatography with ultraviolet detection or mass spectrometry. Liquid chromatography–tandem mass spectrometry is used to detect and quantify SR9009 in biological matrices, including urine and blood, for anti-doping or pharmacokinetic studies. Nuclear magnetic resonance spectroscopy can confirm molecular structure. Stability depends on form and storage: the solid is generally more stable than solutions, and repeated freeze–thaw cycles may degrade samples. Purity is typically reported as a percentage from a certificate of analysis.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Common supplier description |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water |
| Typical storage | −20 °C, desiccated, dark | For research samples |
| Analytical method | LC-MS/MS | Used for detection and quantification |
| Regulatory status | Prohibited in sport | WADA metabolic modulator class |
At the molecular level, SR9009 binds REV-ERBα and REV-ERBβ and alters their repressive activity on target genes. These nuclear receptors help regulate the circadian clock, lipid synthesis, glucose metabolism, and inflammatory pathways. By changing transcription, the compound can shift the timing or magnitude of downstream metabolic processes in model systems. It does not act through androgen receptors or adenosine receptors, which distinguishes it from several substances sold for athletic performance. Whether the same transcriptional changes occur in humans at tolerable exposures remains an open question because controlled human studies are lacking.
Preclinical reports describe effects on exercise endurance, mitochondrial content, and lipid profiles in rodents, but these findings come from specific experimental conditions. Many studies use high doses or delivery methods that may not translate directly to human use. SR9009 has been reported to have low oral bioavailability and a short half-life, which complicates interpretation of oral dosing studies. It is not established as safe or effective for any indication. Literature discussions often separate its pharmacological mechanism from unverified claims made in fitness and supplement markets.
Handling recommendations for SR9009 in a laboratory setting include storing the solid at low temperature, protected from light and moisture. The compound is often dissolved in dimethyl sulfoxide or ethanol for experiments. Solutions should be prepared with appropriate personal protective equipment and disposed of according to local rules. Stability data for long-term storage are limited, so stock solutions are typically kept cold and used within defined periods. Records of preparation date and concentration support reproducibility.
SR9009 is not approved as a medicine by major regulatory agencies. It is commonly sold as a research chemical, a category that may fall outside customary drug approval and quality rules. In sports, the World Anti-Doping Agency lists SR9009 as a prohibited substance. Athletes who use it can face sanctions if it is detected in a sample. Legal status varies by country, and importation may be restricted. Enforcement practices differ across borders.
Detection of SR9009 in biological samples usually employs liquid chromatography coupled with tandem mass spectrometry. This method can identify the parent compound and sometimes metabolites in urine or blood. Because exposure can be low and clearance may be rapid, sample timing and limits of detection matter. Laboratories validate assays for sensitivity and specificity. Results are interpreted alongside chain-of-custody and quality-control records. Urine is the common matrix for anti-doping analysis, while blood may be used in research settings.
=== Chipper teeth === Chipper chain invented by Joseph Cox improved dramatically on the performance of scratcher chain. Chipper used a tooth that was curled over the top of the chain, with alternate teeth pointing left and right. Ahead of the tooth was a depth gauge, which allowed for good clearance around the tooth for chip clearing while limiting the depth of cut and preventing grabbing or overloading. Chipper chains are sometimes used for dirty work, since their very large working corner allows the cutter to retain its effective sharpness for a long time in abrasive conditions.
=== Switzerland === The Swiss government agreed to contribute to the security costs borne by the cantons of Geneva, Vaud and Valais. The Swiss Armed Forces were authorised to deploy up to 5,000 personnel in support of the cantonal authorities. In Geneva, approximately 7,400 police officers, soldiers and customs personnel were mobilised for the summit period. The canton of Geneva estimated the security cost at around 20 million Swiss francs, while a fund of 6 million Swiss francs was created to support businesses affected by possible unrest or security restrictions. Switzerland and France also approved a joint military cooperation framework for the summit, setting out procedures for coordination between the Swiss Federal Department of Defence, Civil Protection and Sport and the French Ministry of the Armed Forces. The summit led to the cancellation of public 2026 FIFA World Cup fan zones in Geneva and Lausanne.
=== Microscopy === Microscopy of the skin sample obtained from the biopsy is used to detect the presence of cleavage within the dermis, epidermal acantholysis (breaking apart of the skin), dyskeratotic keratinocytes and vacuolar changes in the layers of the skin, interfacial dermatitis, and epidermal exocytosis. Presentation of these characteristics suggests PNP.
Sources: en.wikipedia.org
=== Culinary === Also known as "poor man's saffron", the petals are edible and can be used fresh in salads or dried and used to color cheese or as a substitute for saffron. Calendulas have a mildly sweet taste that is slightly bitter, and as it dries these flavors become more intense. It can be used to add color to soups, stews, poultry dishes, custards and liquors. The common name for Calendula officinalis in Britain is 'pot-marigold', named so because of its use in broths and soups.
dihi (디히) → di (디) → ji (지) The Middle Korean form dihi is found in several books from the Joseon period (1392–1897). In Modern Korean, the word remains as the suffix -ji in the standard language (as in jjanji, seokbak-ji), and as the suffix -ji as well as the noun ji in Gyeongsang and Jeolla dialects. The unpalatalized form di is preserved in P'yŏngan dialect.
In many metabolic reactions, a protein that acts as an electron carrier binds to an enzyme that acts as its reductase. After it receives an electron, it dissociates and then binds to the next enzyme that acts as its oxidase (i.e. an acceptor of the electron). These interactions between proteins are dependent on highly specific binding between proteins to ensure efficient electron transfer. Examples: mitochondrial oxidative phosphorylation chain system components cytochrome c-reductase / cytochrome c / cytochrome c oxidase; microsomal and mitochondrial P450 systems. In the case of the mitochondrial P450 systems, the specific residues involved in the binding of the electron transfer protein adrenodoxin to its reductase were identified as two basic Arg residues on the surface of the reductase and two acidic Asp residues on the adrenodoxin. More recent work on the phylogeny of the reductase has shown that these residues involved in protein–protein interactions have been conserved throughout the evolution of this enzyme.
== Ionization mechanism == Ionization in the gas phase by APCI follows the sequences: sample in solution, sample vapor, and sample ions. The effluent from the HPLC is evaporated completely. The mixture of solvent and sample vapor is then ionized by ion-molecule reaction. The ionization can either be carried out in positive or negative ionization mode. In the positive mode, the relative proton affinities of the reactant ions and the gaseous analyte molecules allow either proton transfer or adduction of reactant gas ions to produce the ions [M+H]+ of the molecular species. In the negative mode, [M−H]− ions are produced by either proton abstraction, or [M+X]− ions are produced by anion attachment. Most work on the APCI-MS analysis has been in positive mode. In the positive mode, when the discharge current of corona discharge is 1-5 μA on the nebulized solvent, N2 gas molecules are excited and ionized, which produce N4+*. The evaporated mobile phase of LC acts as the ionization gas and reactant ions. If water is the only solvent in the evaporated mobile phase, the excited nitrogen molecular ions N4+* would react with H2O molecules to produce water cluster ions H+(H2O)n. Then, analyte molecules M are protonated by the water cluster ions. Finally, the ionization products MH+(H2O)m transfer out from the atmospheric-pressure ion source. Declustering (removal of water molecules from the protonated analyte molecule) of MH+(H2O)m takes place at the high vacuum of the mass analyzer. The analyte molecule ions detected by MS are [M+H]+.
Sources: en.wikipedia.org
Legality depends on the country and the intended use. In many places it is sold as a research chemical, but sports and medicine regulations restrict it.
Detection commonly uses liquid chromatography–tandem mass spectrometry. This method can identify the compound in urine or blood at low concentrations.
Typical guidance is −20 °C, dry, and protected from light. Solutions should be aliquoted and limited freeze–thaw cycles should be used.
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.